Maintenance / Cleaning; Surface Maintenance - Forno FRHWM5029-36 Manuel D'instructions

When the range hood is off, press and hold the K1 button for 3 seconds to enter the clock adjustment
mode, press the K4 increase button and the K3 decrease button to adjust the hour, press the K1 button
again to adjust the minutes, also press the K4 increase button and the K3 decrease button to adjust
minutes.
K2: Light button
Press this button to turn on the light, and once again to turn off light.
K3, K4: Decrease button and Increase button
Press these two buttons to adjust the speed when the range hood is on and to adjust the time when the
range hood is in clock mode.
MAINTENANCE & CLEANING

Surface Maintenance:

Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive
detergent (e.g. comet powder scrub, EZ-Off oven cleaner), or steel wool/scoring pads which will scratch
and damage surface.
For heavier soil, use liquid degreaser such as 'Formula 409' or 'Fantastic' brand cleaner.
After cleaning, you may use non-abrasive stainless steel polish/cleaners such as 3M or ZEP, to polish
and buff out the stainless luster and grain. Always scrub lightly, with clean cotton cloth, and with the
grain.
Stainless Steel Baffle Filters:
The factory filters are intended to filter out residue and grease from cooking. They do not need to be
replaced on a regular basis but they must be kept clean.
Filters should be cleaned after every 30 hours of use.
Remove and clean by hand in a basin of hot soapy water. The filter is also dishwasher safe.
If heavily soiled, spray 'Formula 409' or equivalent degreasing detergent and leave to soak.
Dry filters and re-install before using hood.
Oil cup
The oil cup should be cleaned often according to the amount of oil in the cup.
Clean oil cup by hand in a basin of hot soapy water.
If heavily soiled, spray 'Formula 409' or equivalent degreasing detergent and leave to soak.
Slide oil cup out/in from the slot at the bottom of the block
14