Dirt Devil Endura Upright Guide D'utilisation page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Any other servicing should be done by an authorized service representative. If appliance is not
working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it
to a service center prior to continuing use.
WARNING
PROBLEM
POSSIBLE CAUSE
Vacuum
1. Power cord not firmly
won't run
2. No voltage in wall plug.
3. Blown fuse or tripped
4. Thermal Protector activated.
Dust escaping
1. Dirt cup full.
from vacuum
2. Dirt cup not installed
3. Hose not installed correctly.
4. Rinsable and/ or Filter
Smoky/burning
1. Belt broken or stretched.
smell detected
2. Brushroll is clogged.
Vacuum tools
1. Hose clogged
won't pick-up
2. Dirt cup full
3. One or both filters are
4. Vacuum not picking
Cord rewind does
5. Cord reel des not retract.
not work
NOTE: Any other servicing should be done by an authorized service representative. If appliance
is not working as it should, has been dropped, damaged, left outdoors or dropped into water,
take it to a service center prior to continuing use.
To reduce the risk of personal injury - Unplug before cleaning or servicing.
plugged into outlet.
breaker.
correctly.
made with HEPA media
not installed completely.
clogged.
up debris.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse/reset breaker in home.
4. Unplug and allow vacuum to cool for 30min.
(This willl reset the thermal protector)
1. Empty dirt cup.
2. Review Dirt Cup removal & replacement.
3. Review Hose installation.
4. Review Filter Removal and Cleaning.
1. Replace brushroll belt.
2. Clear/remove debris from brushroll.
1. Remove hose and tools; remove obstruction.
2. Empty dirt cup.
3. Remove both filters and clean.
5. Brushroll could be turned off or the belt
could be broken.
5. Call 1-800-321-1134 for the nearest
authorized service representative.
19

Publicité

Table des Matières
loading

Table des Matières