BH BLADEZ 200E Guide D'utilisation page 15

STEP 3
1. Remove and set aside the preinstalled mounting hardware at the top of the main base.
This hardware will be used to install the handlebar post (B).
2. Pass the handlebar post (B) through the handlebar post cover (B-16).
3. Connect the upper cable wire (B-9) to the lower cable wire (D-2).
4. Slide the handlebar post (B) down onto the base assembly. Align the mounting holes and
thread the allen bolt (B-11) and spring washers (B-10) and flat washers (B-7) and semicircle
washers (B-8) in place as shown.
5. Insert the wave washer (F-3) onto the axles of handlebar post (B.)
6. Insert the right lower handlebar (C-6R) onto the axle by using 1 flat washer (F-1)
and 1 nylon screw (F-2).
7. Insert the left lower handlebar (C-6L) onto the axle by using 1 flat washer (F-1)
and 1 nylon screw (F-2).
TM
ASSEMBLY INSTRUCTIONS
Register your product warranty online at: www.BHFitnessUSA.com
Questions regarding warranty and parts call: 636.634.2217
F17: Box Spanner
B-8: M8 (2)
B-7: Ø8*Ø19*2T( 4)
B-10:Ø 8( 6)
F18: Allen Key
B-11: M8*P1.25*16L(6)
F-3:Ø20*Ø30*0.3T (2)
F-1: Ø8*Ø25*2T( 2)
F-2: M8*P1.0*20L (2)
15