Instructions On Disposal; Contents Of Package; Installing The Appliance - Bosch B22CS51SNS Notice De Montage Et D'utilisation

en-us

Instructions on disposal

* Disposal of packaging
The packaging protects your appliance from damage
during transport. All utilized materials are environmentally
safe and recyclable. Please help us by disposing of the
packaging in an environmentally friendly manner.
Please ask your dealer or inquire at your local authority
about current means of disposal.
* Disposal of your old appliance
Old appliances are not worthless garbage! Valuable raw
materials can be reclaimed by recycling old appliances.
,
WARNING:
Redundant appliances
1. Pull out the mains plug.
2. Cut off the power cord and discard with
the mains plug.
3. Do not take out the trays and receptacles to
prevent children from climbing in!
4. To prevent children from locking themselves in
the redundant appliance:
Remove appliance doors!
5. Do not allow children to play with the redundant
appliance. Risk of suffocation!
Refrigerators contain refrigerant and gases in the
insulation. Refrigerant and gases must be disposed of
professionally. Ensure that tubing of the refrigerant circuit
is not damaged prior to proper disposal.

Contents of package

After unpacking all parts, check for any damage during
transport.
,
CAUTION:
Do not set up the appliance if it is damaged.
If there are any problems, please contact the dealer from
whom you purchased the appliance, or our customer
service.
The delivery consists of the following parts:
Free-standing appliance
■
Interior fittings (depending on model)
■
Bag containing installation materials
■
Instruction manual
■
Installation instructions
■
Customer service booklet
■
Warranty enclosure
■
Information on the energy consumption and noises
■
6

Installing the appliance

Have a technician install and connect the appliance
according to the enclosed installation instructions.
,
WARNING:
Do not install this appliance:
outdoors,
■
in an environment with dripping water,
■
in rooms where there is a risk of frost.
■
Transport
The appliance is heavy. It must be secured during
transport and installation.
Due to the appliance's weight and dimensions and to
minimize the risk of injuries or damage to the appliance,
at least two people are needed for safe installation of the
appliance.
Installation location
A dry, well ventilated room is suitable as an installation
location. The installation location should not be exposed
to direct sunlight and not placed near a heat source, e.g.
a cooker, radiator, etc. If installation next to a heat
source is unavoidable, use a suitable insulating plate or
observe the following minimum distances from the heat
source:
To electric or gas cookers 1
■
To an oil or coal-fired cooker 11
■
If installing the appliance next to another refrigerator
or freezer, ensure a minimum lateral distance of
1" (25 mm) to prevent the formation of condensation.
If a panel or cupboard is installed above the appliance,
ensure that a gap of 1¼" (30 mm) is left so that
the appliance can be pulled out of the recess if required.
The air heated on the rear side of the appliance must be
allowed to escape unhindered.
Subsurface
,
CAUTION:
The appliance is very heavy.
Model with dispenser: 317 lbs (143 kg)
The floor of the installation location must not give way;
if required, reinforce floor.
To ensure that the doors can open all the way, observe
lateral minimum distances when installing the appliance
in a corner or recess (see "Installation dimensions").
If the depth of the adjacent kitchen equipment is more
than 22\" (60 cm), observe lateral minimum distances
in order to utilize the full door opening angle (see
chapter "Door opening angle").
/ " (3 cm).
1
4
/ " (30 cm).
13
16