Overhead Rigging - JB Systems LED ROTOGOBO Mode D'emploi

ENGLISH
DESCRIPTION:
1. Safety eye: here you can attach an optional safety cable when you are rigging the LED ROTOGOBO in
a light bridge
2. Mains input with IEC socket and integrated fuse holder: Connect the supplied mains cable here.
Always use a fuse with exactly the same specifications as the original one !
3. Mains output: you can use a special IEC male/female power cable to connect this output with the mains
input of the next fixture for easier linking (up to 10A).
4. Bracket: with knob to fasten the unit in the desired position and a mounting hole to fix a truss clamp.
5. Fan: keep the filter free of dust to assure sufficient cooling to the fixture.
6. Dimmer knob: can be used to adjust the dimming level manually.
7. Rotation knob: can be used to adjust the direction and rotation speed or to stop the rotation.
8. Gobo compartment screws: unscrew these to open the gobo compartment.
9. Lens: turn the lens clockwise or anticlockwise to set the focus.

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
OPERATING INSTRUCTIONS
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
 Once connected to the mains the device starts running.
 Point the projector to the wall and adjust the focus to obtain a clear picture.
 Eventually adjust intensity of the light output and the rotating speed of the gobo with the potentiometers (6
& 7) on the back of the unit.
JB SYSTEMS
®
3/24
USER MANUAL
LED ROTOGOBO