JB Systems DYNABARREL Mode D'emploi page 12

ENGLISH
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
This unit is radio-interference suppressed. This product meets the requirements of the current European and
national guidelines. Conformity has been established and the relevant statements and documents have been
deposited by the manufacturer. This device was designed to produce decorative effect lighting and is used in
light show systems.
Mains Input:
Mains Output:
Power consumption:
Fuse:
Sound Control:
DMX connections:
DMX channels used:
Light source:
Size:
Weight:
You can download the latest version of this user manual on our website:
JB SYSTEMS
®
AC 100-240V, 50/60Hz
Total power line load of Max. 10A @ 230V / 50Hz
31 Watt
250V 2A slow blow (20mm glass)
Internal microphone
3pin XLR male / female
1 & 9 channels
1 x 10Watt RGBW LED
331 x 170 x 200 mm
10kg
170
The information might be modified without prior notice
10/54
USER MANUAL
www.jb-systems.eu
DYNABARREL