JB Systems DYNABARREL Mode D'emploi page 7

ENGLISH
which commands from the controller it has to decode. In the next section you will learn how to set the
DMX addresses.
HOW TO SETUP:
MAIN MENU:
 To select any of the menu options, press the [MENU] button
up to when the required option is shown on the display.
 Select the function with the [ENTER] button. The display will
blink.
 Use [DOWN & UP] button to choose the desired menu
option.
 Once the required menu option is selected, press the
[ENTER] button to select.
 Press the [MENU] button for about 2 seconds to store the
setting and to return to running mode. If you don't do this,
the setting will not be stored and after about 8 seconds, the
fixture will return to the previous running mode.
DMX512 Address Setting
Used to set the start address in a DMX setup.
 Press the [MENU] button until
display.
 Press the [ENTER] button to select.
 Use [DOWN & UP] buttons to change the DMX512 address.
 Once the correct address is shown on the display, press the
[ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the
setting and to return to running mode.
Channel Mode
The unit has 2 different channel modes. Refer to the DMX-
chart to see the differences.
 Press the [MENU] button until
display.
 Press the [ENTER] button to select.
 Use [DOWN & UP] buttons to select one of the available
channel modes.
 Once the mode is selected, press the [ENTER] button to
confirm.
 Press the [MENU] button for about 2 seconds to store the
setting and to return to running mode.
/
Master Slave Mode
Used to set the fixture in master or in one of the slave
modes. By choosing the right slave mode you can
improve the impact of the shows.
 Press the [MENU] button until
display.
 Press the [ENTER] button to select.
 Use the [DOWN & UP] buttons to select "master", slave mode 1 or slave mode 2.
 [MASt]: this unit will run its integrated programs and will control the slave fixtures that are connected to
this unit
 [SL I]: the device will run 100% sinchronously with the master device.
 [SL 2]: the device will run sinchronously with the master device, but from time to time the effects will be
inverted to create more diversity in the show.
 Once the right mode is selected, press the [ENTER] button to confirm.
JB SYSTEMS
®
is shown on the
is shown on the
is shown on the
5/54
USER MANUAL
DYNABARREL