General Guide For Fault Handling - Retevis RB22 Mode D'emploi

Classification Function
Public
Functions
Emergent alarm
Busy channel
Keyboard lock
Power saving
Private call
Group call
Digital
functions
Talk around
TDMA direct
Analog channel
Squelch ON
Analog
functions
Squelch level
Monitor
CTCSS/DCS
DTMF signaling:
Users can set and program the DTMF signaling via PC software to disable or enable some advanced function of
radio.
Note: This option only applies to analog mode.

General guide for fault handling

Zone
The power level is for the transmission power level of the current
Power
When the terminal scans a signal on a channel, it will stay on the
Scan
channel to listen, so as to understand the current activity status of
The radio transmits when voice is detected by the microphone
Vox
Busy channel lockout prohibits transmission and prevents i
lockout
nterference to other users when the radio is receiving traffic.
When a transmission times out, the terminal will automatically terminate
TOT
Keyboard lock is used to lock keys to prevent inadvertent key operation.
The radio may be set to automatic or manual lock mode.
Power saving is a preprogrammed function based on time that places
All call
All call is a call to all contacts on the current digital channel.
Talk around allows communications on the repeaters output frequency.
TDMA direct mode is used to divide a direct channel (simplex) into
two time slots to allow efficient channel usage. Multiple parties may share
mode
the channel without interference depending on slot setting.
call
This setting exhibits an open squelch condition where both traffic
Squelch level allows the manual setting of the squelch from 1 to 9.
This controls at what point that audio can be sent to the speaker.
The default value is 4. The lower the set value, the more chance
Monitor allows the user to open the receiver squelch manually
CTCSS / DCS are analog signaling methods used in transmit and receive.
They are typically set to the same value for transmit and receive. Only
signals that match the preprogrammed values will pass to the speaker.
Description
A zone is a group of channels.The radio supports 16
zones and contains up to 4000 channels.
channel, which can be set to high or low power.
the relevant team members.
Emergency alarm has the highest priority.
the transmission and issue a warning sound.
radio into a sleep-wake mode to conserve the battery.
Private call is a one-to-one call.
Group call is a one-to-many call.
An analog call is a call on an analog channel.
and noise can pass to the speaker.
of noise and weak signals being heard.
to listen to on-channel signals.
07