Bimar KPT-2000B 5206LS Notice D'instruction page 17

if the heater is covered or positioned incorrectly. Check
that no other high absorption appliances are
connected to the same power source.
• This device should not be used in any type of vehicle or
in confined spaces (elevators, campers, cars, cabs,
etc..).
• WARNING: this heater is not equipped with a device to
control the room temperature. Do not use this heater
in small rooms when they are occupied by person not
capable of leaving the room on their own, unless
constant supervision is provided.
• The heater must be installed at least 1,8 m above the
floor.
INSTALLATION
• After removing the packing materials, check the integrity of the
heater; if you are unsure, do not use it and ask for qualified
professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they
are potential sources of danger.
• Before connecting the appliance, check that the voltage shown on the
data plate matches that of your electricity. In the event of
incompatibility between the electric outlet and the plug of the heater,
have the outlet replaced with another more suitable type by
professionally qualified personnel, who will make sure that the section
of the wires of the outlet is appropriate for the absorbed power of the
heater. Check that the mains are not connected equipment; high
absorption to prevent overloading and fire risks. Check that the mains
are not connected equipment; high absorption to prevent overloading
and fire risks. In general, the use of adapters or extension cords is not
recommended; if their use is indispensable, they must conform to
existing safety standards and their current capacity (amperes) must
not be less that the maximum of the heater.Attention: before use the
appliance remove the detachable coupon to stick the handle.
17