Makita LXT211 Manuel D'instructions page 9

1
011496
3. Graduation
4. Arrow
This tool employs an action mode changing ring. Select
one of the three modes suitable for your work needs by
using this ring.
For rotation only, turn the ring so that the arrow on the
tool body points toward the mark on the ring. For
rotation with hammering, turn the ring so that the arrow
points toward the mark on the ring. For rotation with
clutch, turn the ring so that the arrow points toward the
mark on the ring.
CAUTION:
Always set the ring correctly to your desired mode
•
mark. If you operate the tool with the ring positioned
halfway between the mode marks, the tool may be
damaged.
Adjusting the fastening torque
1
011496
3. Graduation
4. Arrow
The fastening torque can be adjusted in 16 steps by
turning the adjusting ring so that the graduations are
aligned with the arrow on the tool body. The fastening
torque is minimum when the number 1 is aligned with
the arrow, and maximum when the number 16 is aligned
with the arrow.
1. Action
mode changing
ring
2
2. Adjusting
3
ring
4
1. Action
mode changing
2
ring
2. Adjusting
3
ring
4
Before the actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out any
work on the tool.
Installing or removing the driver bit or drill bit
011497
Turn the sleeve counterclockwise to open the chuck
jaws. Place the bit in the chuck as far as it will go. Turn
the sleeve clockwise to tighten the chuck.
To remove the bit, turn the sleeve counterclockwise.
Installing the hook
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing the bit holder (Optional accessory)
1
2
007470
9
1 . Sleeve
1
1 . Bit holder
2 . Bit