Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12
Problem
Low heat / Low flame when
valve turned to high.
Excessive flare-ups/uneven
heat.
Burners burn with yellow
flame, accompanied by the
smell of gas.
Flames lift away from
burner, accompanied
by the smell of gas, and
possibly difficulties in
lighting.
Burner will not light with
the igniter, but will light
with a match.
Humming regulator.
Burners will not cross light
each other.
"Paint" appears to be
peeling inside lid or hood.
www.napoleongrills.com
Troubleshooting
Possible Causes
For propane - improper lighting
procedure.
For natural gas - undersized
supply line.
For both gases - improper
preheating.
Sear plates installed incorrectly.
Improper preheating.
Excessive grease and ash build
on sear plates and in drip pan.
Possible spider web or other
debris, or improper air shutter
adjustment.
Improper air shutter adjustment.
Dead battery / or installed
incorrectly.
Loose electrode wire or switch
terminal wires.
Wrong replacement igniter.
Improper gap at electrode tip.
Lifting flames on burner.
Normal occurrence on hot days.
Plugged ports along back of
burner.
Grease build-up on inside
surfaces.
Solution
Ensure lighting procedure is followed carefully. All
gas grill valves must be in the off position when the
tank valve is turned on. Turn tank on slowly to allow
pressure to equalize. See lighting instructions.
Pipe must be sized according to installation code.
Preheat grill with both main burners on high for 10 to
15 minutes.
Ensure sear plates are installed with the holes towards
the front and the slots on the bottom. See assembly
instructions.
Preheat grill with both main burners on high for 10 to
15 minutes.
Clean sear plates and drip pan regularly. Do not line
pan with aluminum foil. Refer to cleaning instructions.
Thoroughly clean burner by removing. See general
maintenance instructions. Open air shutter slightly
according to combustion air adjustment instructions.
(This must be done by a qualified gas installer.)
Close air shutter slightly according to combustion air
adjustment instructions. (This must be done by a
qualified gas installer.)
Replace with heavy duty battery.
Check that electrode wire is firmly pushed onto the
terminal on the back of the igniter. Check that the
lead wires from the module to the ignition switch (if
equipped) are firmly pushed onto their respective
terminals.
One spark systems must use a one spark igniter.
Ensure that the collector box is tight and the gap
between the electrode end and the collector box is
between 1/8" - 3/16" (3mm-5mm). The gap can be
adjusted by bending the box in or out.
Close air shutter slightly - see previous problem.
This is not a defect. It is caused by internal vibrations in
the regulator and does not affect the performance or
safety of the gas grill. Humming regulators will not be
replaced.
Clean burner ports. See burner maintenance
instructions.
This is not a defect. The finish on the lid and hood is
porcelain, and will not peel. The peeling is caused by
hardened grease, which dries into paint-like shards,
that flake off. Regular cleaning will prevent this. See
cleaning instructions.
Publicité
Table des Matières
