Beamz DMX240 Manuel D'instructions page 8

EXAMPLE: Program 8 scenes with channel 1-8 at full in sequence into bank 2 and assign these scenes to fixtures 2.
1. Program enable.
2. Tap the Scanner 2 button to turn on its fader control.
3. Tap the Page Select button to select Page A.
4. Push Fader 1 to the top position.
5. Tap the MIDI/Rec button.
6. Select bank 2 using Bank Up/Down button.
7. Tap the Scene 1 button to store the first scene.
8. Repeat steps 4-7 until all 8 scenes have been programmed into bank 2.
9. Tap the Scanner 2 button again to turn off its fader control.
10. Press the Program button for 3 seconds to exit Programming mode.
1.3 SCENE EDITING
NOTE: Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record over an exited scene.
1.4 SCANNER COPY
This function allows you to copy the settings of one scanner to another.
8
1. Program enable.
2. Tap the Bank Up/Down
button to select the bank
that contains the scene
you wish to edit.
3. Select the scene you want
to edit by tapping its Scene button.
6. Tap the Scene button that
corresponds to the
scene you're editing. This will
overwrite the
exited scene.
1. Press and hold down the Scanner button you want to copy.
2. While holding the Scanner button, tap the Scanner button you want to copy to.
4. Use the Faders or jog wheels to
make your desired adjustments.
5. Once you've made your changes,
tap the MIDI/Rec button.