Delete A Step - Beamz DMX240 Manuel D'instructions

2.2 ADD A STEP

2.3 DELETE A STEP

5. Tap the MIDI/Rec Copy button, all LEDs and the Segment Display will flash three times
briefly indicating all 8 scenes in this bank have been programmed into this chase.
1. Program enable.
2. Select the chase you wish to add a step to.
3. Tap the Tap Sync/Display button causing a highlight next to "Step", the first digit in the
Segment Display shows the chase and the next three digits show its step.
4. Tap the Bank Up/Down button to scroll to the step you wish to add a step after.
5. Tap the MIDI/Rec button, the Segment Display will read the step one higher than before.
For example, if you want to insert a step between step 3 and step 4, and you scroll to step
3, when you tap the MIDI/Rec button, the Segment Display will read step 4.
6. Tap the Tap Sync/Display button again, the Segment Display shows the current chase,
scene and bank. Create a desired scene and record it as a new step or select a
programmed scene you wish to add into this chase.
Hints: You may tap the Tap Sync/Display button to change the display mode between step
and the bank.
7. Tap the MIDI/Rec button again, all LEDs and the Segment Display will flash three times
briefly indicating the new step has been inserted into this chase.
1. Program enable.
2. Select the chase that contains the step you wish to delete.
3. Tap the Tap Sync/Display button causing the Segment Display shows the steps.
4. Tap the Bank Up/Down button to scroll to the step you wish to delete.
5. Tap the Auto/Del button to delete the step, all LEDs and the Segment Display will flash
three times briefly indicating that the step has been deleted.
11