Beamz DMX240 Manuel D'instructions page 17

5.2 AUTO MODE
6.0 MIDI OPERATION
6.1 MIDI CHANNEL SETTING
6.2 IMPLEMENTATION
This unit receives Note On signals, which enables to run 15 banks(01-15) of scenes and 6 chases of scenes. In
addition, blackout function can be activated by MIDI signal.
Bank
Bank 1
Bank 2
Bank 3
.............
Bank 14
Bank 15
Chase 1
Chase 2
Chase 3
Chase 4
Chase 5
Chase 6
1. Tap the Auto/Del button to activate Auto mode. The auto LED lights indicating music
mode is active.
2. Select your desired chase by tapping one of the six Chase buttons. A second tap of this
button will deactivate this function.
3. Use the Speed slider (or Tap Sync) and Fade Time slider to adjust the chase to your
desired effects. You may select several chases at a time, the chases will run in sequence
that you select the chases.
1. Press and hold down the MIDI/Rec button for three seconds,
the last two digits of the Segment Display will flash to indicate MIDI
channel setting is ready.
2. Use the Bank Up/Down button to select the DMX channel 01-16
to assign to MIDI channel.
3. Press and hold down the MIDI/Rec button for three seconds to
store your setting and to deactivate MIDI setting. If you wish to give
up your setting, tap any other button(except Bank Up/Down buttons)
to exit MIDI mode.
Note number
00 to 07
08 to 15
16 to 23
..............
104 to 111
112 to 119
120
121
122
123
124
125
126
Function
Turn on or off scenes 1 – 8 of bank 1
Turn on or off scenes 1 – 8 of bank 2
Turn on or off scenes 1 – 8 of bank 3
..............
Turn on or off scenes 1 – 8 of bank 14
Turn on or off scenes 1 – 8 of bank 15
Turn on or off Chase 1
Turn on or off Chase 2
Turn on or off Chase 3
Turn on or off Chase 4
Turn on or off Chase 5
Turn on or off Chase 6
Blackout
17