Beamz DMX240 Manuel D'instructions page 14

3.4 DELETE A SCANNER OF DMX CHANNEL
3.5 CLEAR ALL DMX CHANNELS
3.6 DISPLAY DMX CHANNEL
14
2. Apply the power again, tap the TAP/Display button to change between Fade
time and assign fade time, the LCD reads
ALL CH
FD Time
3. Press the Mode and TAP/Display buttons at a time to store your setting into
memory. If you are not going to save your setting, tap the Blackout button to leave
this operation.
1. Activate assign or reverse mode
2. Tap the scanner button to select the scanner you wish to delete.
3. Press the Mode and Auto/Del buttons at a time, all LEDs should flash briefly,
indicating the scanner is deleted.
1. Turn the power off.
2. Press the Mode and Auto/Del buttons at a time.
3. While pressing the two buttons, apply the power again, all LEDs should flash
briefly, indicating all assigned or reversed DMX channel are cleared.
1. Press the Fine and Mode buttons at a time, the assign LED light.
2. Press the Fine and Mode buttons the second time, the Assign LED goes out
and the Reverse LED light.
3. Tap the scanner button that holds the Pan and Tilt channel, the LCD shows the
Pan and Tilt.
Only X/Y
OR
FD Time