ResMed AirFit N20 Mode D'emploi page 7

AirFit N20 cushion, elbow and short tube (Daily/After each use)
1. Soak and agitate the AirFit N20 cushion, elbow and short tube in
warm water (approximately 86°F/30°C) using a mild liquid detergent
for up to 10 minutes.
2. Clean the components with a soft bristle brush, paying particular
attention to the small vent holes on the elbow.
3. Thoroughly rinse the components under warm flowing drinking quality
water.
4. Inspect each component to ensure that they are visually clean and
free of detergent residue. If required, repeat washing.
5. Allow the components to dry out of direct sunlight before assembling.
Headgear, frame (Weekly)
The magnetic clips on the frame can be left on for washing.
1. Soak and agitate the separated headgear and frame in warm water
(approximately 86°F/30°C) using a mild liquid detergent for up to 10
minutes.
2. To rinse the components, repeatedly squeeze them under warm
flowing drinking quality water until it is free of detergent residue.
3. Squeeze the components to remove excess water.
4. Allow the components to dry out of direct sunlight before assembling.
AirTouch N20 cushion (as required)
CAUTION
• The cushion must not be submerged in liquid as this may damage
the cushion and affect mask performance.
• Discard the cushion if it is submerged in liquid or heavily soiled.
• Do not expose the cushion to domestic cleaning products or
cleaning devices.
You do not need to clean the AirTouch N20 cushion every day. It is
recommended to replace your cushion every month. If any visible
deterioration of the cushion is apparent, the cushion should be discarded
and replaced. If required, wipe the outside of the foam cushion with
CPAP wipes or similar alcohol-free wipes and allow to dry. Do not store or
place the cushion in direct sunlight.
6