ResMed AirFit N20 Mode D'emploi page 6

1. Undo the fastening tabs on the upper headgear straps and pull them
from the frame. Keep the magnetic clips attached to the lower
headgear straps.
2. Remove the elbow from the mask by pressing the side button and
pulling the elbow away.
3. Hold the frame by placing your thumb over the side slot. Pull the
cushion away from the frame.
Reassembling your mask
1. Push the cushion into the frame. The frame has a shape that allows
you to insert the cushion only one way.
2. With the ResMed logo on the headgear facing outside and upright,
thread the upper headgear straps into the frame slots from the inside.
Fold them over to secure.
Cleaning your mask at home
It is important to follow the steps below to get the best performance out
of your mask.
WARNING
• As part of good hygiene, always follow cleaning instructions and
use a mild liquid detergent. Some cleaning products may damage
the mask, its parts and their function, or leave harmful residual
vapors that could be inhaled if not rinsed thoroughly.
• Regularly clean your mask and its components to maintain the
quality of your mask and to prevent the growth of germs that can
adversely affect your health.
CAUTION
Visible criteria for product inspection: If any visible deterioration of a
system component is apparent (cracking, crazing, tears etc), the
component should be discarded and replaced.
Once you have disassembled the mask, clean the components as
follows.
English 5