Changing Factory Defaults; Setting: Minimum Temperature: Heating - Jaga JDPC002 01 Manuel

moscow.ru

CHANGING FACTORY DEFAULTS

The factory settings of the JDPC-module ensure a confortable operation of the device. the jdpc mo-
dule is located under the valve cover plate.
SETTING: MINIMUM TEMPERATURE: HEATING - Factory Presetted: 28°C
The fan will start at this temperature. With a higher setting of the water temperature, the fan
will start later. At a lower setting, the fan will start earlier. When using a heat pump, it may be
necessary to set the water temperature at a lower setting.
OPTION 01 (DPC.CC21/DPC.CC22): JDPC.002 WITHOUT CONTROL PANEL
OPTION 02 (DPC.CC24/DPC.CC25): JDPC.002 WITH CONTROL PANEL
OPTION 03 (DPC.CC71/DPC.CC72): JDPC.002 EN 0-10 VDC INPUT FOR DOMOTICA
How to change the minimum temperature setting?
If the minimum
temperature is reached,
the bleu LED fl ashes
Automatic control: The
This indicates that the supply water is hot.
The JDPC controller returns into normal mode after 30" and will automatically save all modifi ed settings !!
ООО «БСП»
- + +
5x
Press briefl y on the
- +
button to decrease or increase the water
24°C 26°C
- 2°C
I
rapidly.
green LED lights when the water temperature exceeds the set temperature.
- + +
5x
Москва, ул. Народного Ополчения, д. 34, стр. 3
conf onfort orta a ble
Press and hold the
the red LED fl ashed 5x and release.
button or the
temperature by 2 degrees.
28°C 30°C 32°C 34°C
Exit setup mode by holding the
the red LED fl ashed 5x and release.
|
jaga CLIMA CANAL WITH JDPC installation instructions 55
oper r ation n o f o the d e de e vice.
button unti
-
Indien de maximum
36°C 38°C
temperatuur is bereikt,
de rode LED knippert
I
+ 2°C
snel.
button until
(499
the jdpc jdp mo- -
EN EN
+ +