moscow.ru
SETTING: MAXIMUM TEMPERATURE: COOLING - Factory Presetted: 18°C
The fan will start at this temperature. With a higher setting of the water temperature, the fan
will start later. At a lower setting, the fan will start earlier. When using a heat pump, it may be
necessary to set the water temperature at a lower setting.
How to change the minimum temperature setting?
If the minimum
temperature is reached,
the bleu LED fl ashes
Automatic control: The
ture. This indicates that the supply water temperature is colder.
The JDPC controller returns into normal mode after 30" and will automatically save all modifi ed settings !!
SETTING: FANSPEED
Changing these modes has an eff ect on the heat-output and the sound. The higher the set-
ting, the more heat but also the noise-level increases. Sound is a very subjective issue and
is strongly dependent on the acoustic properties of the room. You can fully personalize your
Clima device by adapting it to the acoustics of your rooms or your personal preference.
OPTIE 01 (DPC.CC21/DPC.CC22): JDPC.002 WITHOUT CONTROLPANEL
OPTIE 03 (DPC.CC71/DPC.CC72): JDPC.002 AND 0-10 VDC INPUT FOR DOMOTICA
FANSPEED %
56 CLIMA CANAL WITH JDPC installation instructions
ООО «БСП»
-
+
5x
Press briefl y on the
-
+
button to decrease or increase the water
12°C
14°C
- 2°C
I
rapidly.
green LED
lights when the water temperature is lower than the set tempera-
-
+
5x
-
+
Press Short on the
adjust the speed of the fan(s).
If minimum fanspeed is reached,
I
the bleu LED fl ashes rapidly.
20
25
30
35
Москва, ул. Народного Ополчения, д. 34, стр. 3
Press and hold the
the
blue LED
fl ashed 5x and release.
button or the
temperature by 2 degrees.
16°C
18°C
20°C
22°C
Exit setup mode by holding the
the
blue LED
fl ashed 5x and release.
or the
If maximum fanspeed is reached,
40
45
50
55
60
|
jaga
button unti
-
If the maximum
24°C 26°C
temperature is reached,
the red LED fl ashes
I
+ 2°C
rapidly.
button until
-
button to
the red LED fl ashes rapidly.
65
70
75
80
85
90
Factory Presetted: in %
(499
+
+
+
+
I
95 100