Factory Settings; Fanspeed; Factory Reset - Jaga Dynamic Clima Beam T 20 Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.  FACTORY SETTINGS
7.1.  FANSPEED
Electronic speed control with 0 ... 10V signal (building management system) :
–  min. stand: 50%
–  max. stand: 100%
Configuration code - zie hieronder
Ventilatorsnelheid
CONFIGURATION CODE
1
-
The blue LED flashes quickly as soon as the
minimum speed is reached

FANSPEED %

7.2.  FACTORY RESET
1. Disable power charge .
1
-
4. The controller will return to the Factory settings, all LEDs will flash for 10 seconds. The controller
will return to the Factory Default settings, all LEDs will flash for 8 seconds
Attention: 'Reset to Factory Settings' will erase all of the data, settings and applications and
resets the controller to the original factory settings!
54
Max
Min
0
1
Briefly press the [-] or [+] button to adjust the speed of the
50
55
60
2. Ccontroller
3. Press and hold down both the [-] and [+] button on the circuit board
and switch on the power again. The blue LED will light up, followed
by the green LED 2 seconds later and the red LED 4 seconds later.
Release the buttons as soon as all 3 LEDs are flashing
0-10V input
10
fan
The red LED flashes quickly as soon as the
maximum speed is reached.
65
70
75
80
1
-
85
90
95
100
Factory preset: in %

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dynamic clima beam t 21

Table des Matières