Astralpool Viron P300 Manuel D'installation Et Maintenance page 9

START-UP
- Open all the valves and connect the motor.
- Activate the self-priming and wait a reasonable amount of time for this to be
completed.
5. MAINTENANCE
- Clean the pre-filter basket regularly to avoid drops in pressure. TO prevent the basket
from breaking, do not hit it during the cleaning process.
- Should the pump stop, check that the consumption of the running motor in amperes is
equal to or below that indicated on the manufacturer's characteristics plate. If this
information is not available, contact the nearest Technical Assistance Service.
- Where the amperage is higher, consult the manufacturer.
- Empty the pump if it is to remain at a standstill for a certain length of time, especially in
cold countries where there is a risk of freezing.
- Remove the purge cap (10) to empty the pump.
- Every time the pre-filter is opened, clean the seal and its seating of any impurities to
ensure air tightness when the cap is closed (Fig. 5).
- Pump components that, due to their normal use, suffer wear and/or tear must be
regularly replaced to ensure good pump performance. The following table shows the
perishables and/or consumables used in the pump and their estimated working life.
COMPONENT DESCRIPTION
The
of the parts above has been established according to the normal product use and installation
conditions.
Follow the instructions in the installation manual to maintain the working life of the pump.
6. REMOVAL
-
The motor unit can be removed from the pump body without having to disconnect the
pump's suction and return pipes.
-
To remove the Motor unit from the pump body, remove the screws joining them
together.
Inst256 Installation and General Maintenance Manual – Viron P300 Pool Pump
0 rings and general seals
Mechanical Seal
Bearings
ESTIMATED WORKING LIFE
1 year
1 year
1 year
estimated
working life
9