Insert Preparation - Zephyr Essentials Monsoon II Guide D'utilisation, D'entretien Et D'installation

1
1. 1)
front of insert. 2)
3. Remove left and right side spacer panels by
5. Secure 10" round ducting collar to top of insert by
2
2. Remove grease tray by: 1) Pulling up on tray to
4. Remove bottom panel by: 1)
6. Hood preperation is complete. Refer to page 10,
11
1
2
release from bottom panel. 2) Lifting tray out of
insert body.
1
Bottom Panel Screws
2
Locking Tabs
screws from left and right sides of bottom panel.
2) Pulling bottom panel toward front of insert to
release from locking tabs.
step 4 to complete installation.
1
2