Installing The One Piece Insert - Zephyr Essentials Monsoon II Guide D'utilisation, D'entretien Et D'installation

!
CAUTION: At least two installers are
required due to the weight and size of the
hood.
If possible, power up and test all functions prior to installation.
Use caution during installation to prevent scratches or damage to the
stainless steel.
2. Cut out an opening in the bottom of the cabinet by following the
dimensions in FIG. 1.
3. Prepare insert for installation into cabinet by following the steps on
page 11.
4. Lift insert into bottom opening of cabinet and secure to interior of
WARNING: Make sure the surface you are securing the insert to
is capable of holding the weight of AK93. Failure to do so may
cause personal injury or damage to cooking surface or counter.
5. Finalize installation of electrical and duct work. Seal duct work with
duct tape and verify proper operation.
NOTE: If access to top of insert is not available after installation,
electrical and duct work connection may need to be made prior to
installing the insert.
6. Re-install the previously removed bottom panel, side spacer panels,
10
www.zephyronline.com
FIG. 1
FIG. 2