Custom Hood Preparation & Installation - Zephyr Essentials Vortex AK9028AS Guide D'utilisation, D'entretien Et D'installation

!
CAUTION: At least two installers are
required due to the weight and size of the
hood.
If possible, power up and test all functions prior to installation.
1. Remove baffl e fi lter, all packing materials and
protective fi lm prior to installation. Use caution
during installation to prevent scratches or damage
to the stainless steel.
2. Prepare custom hood enclosure by following the
dimensions in FIG. 1.
3. Install liner into custom hood. FIG. 2, Page 11.
WARNING: Make sure the surface you are securing the
liner to is capable of holding the weight of AK90. Failure
to do so may cause personal injury or damage to cooking
surface or counter. Wood blocking may need to be added
to cabinet base if additional support is needed.
4. Secure front panel to custom hood. FIG. 3, Page 11
5. Finalize electrical and duct work. Seal duct work
with certifi ed aluminum duct tape.
Note: If access to the top of the liner is not available
after installation, duct work and electrical connection
may need to be installed prior to installing the liner.
6. Power on the liner, check for leaks around duct tape
and test for proper operation.
7. Re-install baffl e fi lter.
Recommended
Side Panel Thickness:
-
1/16
Plywood Base
Custom Hood
Model Exterior Width
AK9028AS 30 inches
AK9034AS 36 inches
Cut-Out
Width (C)
Model
AK9028AS
26- "
5/8
AK9034AS
*Dimension does not include 3/8" wide flange around liner.
**Assumes backboard thickness of 3/8"
10
www.zephyronline.com
3/4''
FIG. 1
Inside Inside Depth* (B)
Width* (A)
Without Backboard
28 "
1/2
17 " - 20
1/2 1/2
34 "
1/2
Rear Base
Cut-Out
Depth
Depth (D)
Without Backboard
10- "
1/2 1- 3/8 "
FIG. 1
3/8" Wide Flange
With Backboard**
" 17 " - 20 "
1/8 1/8
(E)
With Backboard**
1"