Vibration Information - IKEA FIXA Instructions Originales

Keep the battery charger clean.
Contamination can lead to danger of an
electric shock.
Before each use, check the battery
charger, cable and plug. If damage
is detected, do not use the battery
charger. Never open the battery
charger yourself. Have repairs
performed only by a qualified
technician. Damaged battery chargers,
cables and plugs increase the risk of an
electric shock.
Do not operate the battery charger
on easily inflammable surfaces (e. g.,
paper, textiles, etc.) or surroundings.
The heating of the battery charger during
the charging process can pose a fire
hazard.
Children should be supervised to
ensure that they do not play with the
battery charger.
Products sold in GB only: Your product is
fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362). If the plug is not suitable for
your socket outlets, it should be cut off
and an appropriate plug fitted in its place
by an authorised customer service agent.
The replacement plug should have the
same fuse rating as the original plug. The
severed plug must be disposed of to avoid
a possible shock hazard and should never
be inserted into a mains socket elsewhere.
Products sold in AUS only: Use a residual
current device (RCD) with a rated residual
current of 30 mA or less.

VIBRATION INFORMATION

Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given
in UL 60745 / CSA C22.2 No. 60745. It
may be used to compare one tool with
another and as a preliminary assessment
of exposure to vibration when using the
tool for the applications mentioned in
this manual. However,
different applications, or with different
or poorly maintained accessories, may
significantly increase the exposure level.
An estimation of the level of exposure to
vibration should also take into account
the times when the tool is switched off or
when it is running but not actually doing
the job, as this may significantly reduce
the exposure level over the total working
period.
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm,
and organising your work patterns.
ASSEMBLY
Before any work on the machine
(e. g., maintenance, tool change, etc.) as
well as during transport and storage,
set the rota tional direction switch
to the centre posi tion. Unintentional
actuation of the On/Off switch can lead to
injuries.
Battery charging
Charging your screwdriver/drill
When the charger is connected to the
electricity supply, the red diode on the
screwdriver/drill lights up. The diode lights
up while the battery is being charged (7).
using the tool for
8