Vibration Information - IKEA FIXA Mode D'emploi

Safety Warnings for battery chargers
For indoor use only.
Double insulated.
Keep the battery charger away from rain or
moisture. Penetration of water in the battery
charger increases the risk of an electric shock.
Do not charge other batteries. The battery
charger is suitable only for charging the batteries
that were supplied with your power tool.
Otherwise there is danger of fire and explosion.
Keep the battery charger clean. Contamination
can lead to danger of an electric shock.
Before each use, check the battery charger,
cable and plug. If damage is detected, do
not use the battery charger. Never open
the battery charger yourself. Have repairs
performed only by a qualified technician.
Damaged battery chargers, cables and plugs
increase the risk of an electric shock.
Do not operate the battery charger on easily
inflammable surfaces (e. g., paper, textiles,
etc.) or surroundings. The heating of the battery
charger during the charging process can pose a
fire hazard.
Children should be supervised to ensure that
they do not play with the battery charger.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362). If the
plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in
its place by an authorised customer service agent.
The replacement plug should have the same fuse
rating as the original plug. The severed plug must
be disposed of to avoid a possible shock hazard
and should never be inserted into a mains socket
elsewhere.
Products sold in AUS only: Use a residual current
device (RCD) with a rated residual current of 30
mA or less.

VIBRATION INFORMATION

Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
62841. It may be used to compare one tool with
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned in this manual. However,
using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job, as this may significantly
reduce the exposure level over the total working
period.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organising your work
patterns.
ASSEMBLY
Before any work on the machine (e.g.
maintenance, tool change, etc) as well as
during transport and storage, set rotational
direction switch to the centre position.
Unintentional actuation of the trigger can lead to
injuries.
Charging your screwdriver/drill
When the charger is connected to the electricity
supply, the red diode on the screwdriver/drill
lights up. The diode lights up while the battery is
being charged (8).
Under normal conditions of use the screwdriver
can be recharged several hundred times.
ATTENTION! The recharging process generates
heat in the battery.
7