Hitachi RAK-18PED Mode D'emploi page 7

2. CLEANING OF FRONT PANEL
Remove the front panel and wash with clean water.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with
clean water.
When front panel is not removed, wipe it with a soft
dry cloth. Wipe the remote controller thoroughly with
a soft dry cloth.
Wipe the water thoroughly.
If water remains at indicators or signal receiver of
indoor unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to
detach and attach it.
Removing the Front Panel
2
Arm
Push
Push the end of the right-side arm outward to release
1.
the tab.
2. Move the left-side arm outward to release the left tab,
and then pull the panel towards you.
CAUTION
Do not splash or direct water to the body of the unit when cleaning it as
this may cause short circuit.
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or a
brush, because they will damage the plastic surface and the coating.
1
Insert the shaft of the left arm along the step on the
1.
unit into the hole.
2. Securely insert the shaft of the right arm along the
step on the unit into the hole.
Make sure that the front panel is securely attached,
3.
and then close the front panel.
Attaching the Front Panel
Arm
A
C
I
D