Fermax iLOFT BUS2 Manuel D'installation Et Utilisation page 29

iLOFT Monitor
iLOFT Monitor
Image Settings (contrast, shine, colour)
30 sec.
The ILOFT monitor has 5 pre-defined levels for contrast, shine and colour settings.
- Accessing «Contrast Settings» Mode:
1 - Auto-Start: Press and hold the
2- Press and hold the «
You will hear a confirmation tone and the contrast settings menu will appear on the
screen.
c n 3
- Accessing «Shine Settings» Mode:
While in «Contrast Settings» mode, press the «
b r 5
- Accessing «Colour Settings» Mode:
While in «Shine Settings» mode, press the «
c l 5
- Exit «Image Settings»: While in «Colour Settings» mode, press the «
Note: If the monitor switches off because 30 seconds have elapsed since you began
programming, the most recent selection shown on screen for each setting will be saved.
Auto-Start (See image on the monitor)
(1sec.)
: Contrast Settings (cn)
(5 sec.)
: Shine Settings (br)
: Colour Settings (cl)
: Exit Settings
» button for 5 seconds.
- press the
- press the
- press the
- press the
- press the
- press the
button until you see the image on the screen.
button to increase the contrast level.
button to reduce the contrast level.
» button:
button to increase the shine level.
button to reduce the shine level.
» button:
button to increase the colour level.
button to reduce the colour level.
cn3
» button:
Page 29