Operation - Fermax iLOFT BUS2 Manuel D'installation Et Utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
iLOFT Monitor
iLOFT Monitor
iLOFT Monitor
iLOFT Monitor

Operation

NOTES:
The monitor screen goes on once the call from the panel has ended.
If there is more than one iLoft monitor in the system and a call is made to one of the
monitors, the rest of the monitors will show a blue led, warning that the channel is busy.
Page 26
Answering a call.
When the call button on the Entry Panel is pressed a ring tone is
emitted both from the panel and on the monitor, causing the screen
to start up.
Press the button
between the entry panel and the residence will be opened;
operating in hands-free mode. The communication will
automatically end after 90 seconds, or at any time by pressing the
button .
The led will remain on (blue) for the duration of the conversation.
If communication is not established with the entry panel, the monitor
will automatically switch off after 30 seconds.
Opening the Door
When a call is received from the entry panel, you can open the door
at any time, by pressing the
Manual Monitor Activation (Auto-Start)
With the monitor on standby, press and hold the
second to switch the monitor on manually. To sequentially select
between the main camera and the secondary camera (where one
exists), press and hold the
To activate the audio and speak to the visitor or open the door,
follow the steps above.
If communication is not established with the entry panel, the monitor
will automatically switch off after 30 seconds.
to speak with the visitor. The audio channel
button.
button for 2 seconds.
button for 1

Publicité

Table des Matières
loading

Table des Matières