Hot Water Supply; Cup Warmer Use - Dalla Corte evo2 Notice Pour L'utilisateur

Hot water supply

This machine has 2 automatic preset time-dosed
hot water buttons for tea.
Place a container (that can bear a temperature of
at least 125°C) under the hot water spigot (
and push one of the two
(Pic. 3).
The quantity and temperature of hot water for

Cup warmer use

In some cases, environmental conditions can
create cold air flows that may affect and divert
the normal hot air flow from boiler into cup, thus
preventing cups to reach the correct temperature.
If the cup is not suitably heated when coffee is
poured, there will be an immediate drop of 25-
35°C in coffee temperature and therefore a luke-
warm espresso will be obtained.
6
Pic. 2)
P8-P10 hot water buttons
infusions can be set during machine installation;
this setting must be carried out exclusively by the
installer.
WARNING
Avoid pushing hot water buttons before placing
the pipe into a container to avoid getting burned.
The cup warmer of this machine is electric, so
it can be enabled or disabled by pushing the
button (Pic.3). The cup warmer is heated in its
rear part.
When the cup warmer is enabled, an upside-down
cup icon is displayed.
The cup warmer function has 2 heating levels: by
pushing P7 once, the cup warmer works inter-
mittently providing medium heating. In this case,
the cup warmer icon blinks on the display.
By pushing the P7 button for a second time, maxi-
mum heating is set and the icon on display stops
blinking.
Push P7 again to turn off the cup warmer; the icon
on the display will disappear.
P7
45