Error Messages - JCM 2000-CODE MAIN UNIT-DCS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

7.2 DELETING MODE
• Press the "PROGRAMMING" button. The red programming LED will light up and you
will hear a long audio signal.
• Enter the "password".
• Select the location to be deleted with the
• Press the
button (Delete) on the front panel.
C
• The occupied location decimal point will go out indicating that the location has been
deleted (it will become free).
7.3 ERASING THE WHOLE OF THE MEMORY
!
This function will erase all information (codes) which are held in the memory.
• Press the "PROGRAMMING" button. The red programming LED will light up and you
will hear a long audio signal.
• Enter the "password".
• Bridge the two terminals marked "MR" with the tip of a screwdriver for two seconds.
You will hear a bleeping audio signal and see the word "RESET" on the screen confirming
that the whole of the memory has been erased.

7.4 ERROR MESSAGES

Some of the errors which can occur if there is a malfunction, whether is programming
mode or function mode, can be seen on the screen according to the following table.
Error shown
2001
EA01
EA02
EA03
EA04
EA05
EA06
A1A1
(*) This is not a fault, but shows up as an error.
(Up) and
Description
Invalid code (*)
Unused memory (*)
Location occupied
Code written in another location
Communication error
Damaged memory error
Wrong Client or Installer Code
Unit inhibited
22
(Down) buttons.

Publicité

Table des Matières
loading

Produits Connexes pour JCM 2000-CODE MAIN UNIT-DCS

Table des Matières