General Information; Technical Information - JCM 2000-CODE MAIN UNIT-DCS Mode D'emploi

This controller is prepared to memorise "Dynamic Code" transmitter codes and access
control units (smart cards and/or proximity keys).

1. GENERAL INFORMATION:

Frequency
Code memorising system
Memory capacity
Memory type
Antenna
Connection of smartcard drives
Proximity key reader connection
Certification
* UK only

2. TECHNICAL INFORMATION:

Power supply
Access control input
Sensitivity
Consumption at rest
Working temperature
Dimensions
3. DESCRIPTION OF BASE PLATE MICROSWITCHES
GROUP OF 4 MICROSWITCHES
Microswitch
N°
Multi-Channel Mode
1
No Zone Mode
2
No Antiscanning
3
Manual Programming
4
Single-Channel Mode: If only relay 1 is used and control units with more than 1 channel
are available, allows selection of which channel will activate the relay for each user
(memory position).
Multi-Channel Mode: The central unit always activates the relay pertaining to the channel
pressed on the transmitter (relay 1 with channel 1, relay 2 with channel 2...), regardless
of the channel used to record the command.
Zone Mode: Selects the channels operating in the central unit for each command (memory
position). When the central unit is programmed and ready to save commands to memory,
only those channels pressed will be operative. This option is of no use if the central unit
is operated in single-channel mode.
2000-CODE MAIN UNIT-DCS
433.92 MHz or 418 MHz*
Self-teaching or via programmer
2000 codes
Extractable EEPROM mini-card
Built-in, adjustable or active Antenna (optional)
Maximum 6 drives
4 normal mode - 6 reduced mode
European regulations EN 300 220-I
220 V or 12/24 V AC/DC
SI
Better than -100 dBm
110 mA at 12/24 V AC/DC - 6 mA at 220 V
0 to 70°C
222x156x114mm
Function
OFF
Single-Channel Mode
Zone Mode
Antiscanning*
Auto Programming
ON
17
ON
1 2 3 4