JCM 2000-CODE MAIN UNIT-DCS Mode D'emploi page 18

5. DESCRIPTION OF THE MOTHERBOARD
Zone Mode Microswitch
Single/Multichannel
Mode Microswitch
Memory Card
Reset Jumper
Battery Card Connector
Anti-Passback Card Connector
12/24 V Selector Jumper
(Only 12/24 V version)
6. INSTALLATION
Disconnect the power from the controller before handling the controller.
STOP
• Transmitters or other access control units (smarts cards and/or proximity keys)
to be used can only be from the DYNAMIC CODE SYSTEM range. If you use
other types of equipment, the Controller will not carry out any operations.
• Connect the power supply cables to the poles marked 12/24V - 220V, following the
indications shown on the latter:
- If you work at 12 or 24 V select this power supply by means of the selector bridge
marked 24V--12V.
- If you work with continuous current, you should take the fact that the positive pole is
no. 1 of the connectors in the centre of the motherboard into account.
• Connect the cables from the access control units and/or antenna to the poles marked
with the printed circuit +, - and S, following the instructions shown on the latter.
6.1 OPTIONAL CARDS
1 1
24V--12V
CONNECTORS R3 and R4
• Relay cards, which will give you up to four channels.
19
Antiscanning Mode ON/OFF
Microswitch
Auto/Manual Programming
Microswitch
Pulse/Bistable 2 Microswitch
Pulse/Bistable 1 Microswitch
Connector for anti-panic card
Printer/PC Card Connector
Connectors for relay cards