Lanaform Living Mode D'emploi page 7

"Humidifi er" mode
Just select the emission intensity you require.
"Essential oils diff user" mode
You will need to remove the top of the device (j), the diff user sprinkler tip (i) and the aroma ring (g). Then pour a few drops (3 to 4 drops at
most) of essential oils onto the essential oils foam tab contained in this aroma ring (h). Finally, replace the ring on the top of the device (f)
(g) and put the sprinkler tip back into position (i). Your essential oils diff user is now ready for operation and will disperse a pleasant scent (j).
8) Press the on/off button (Scheme 1, item 11) and the device will start to work.
You can either use the device in continuous mode or programme it with a timer.
In continuous mode:
Press the on/off button to adjust the cold-mist level, the light will change colour and a beeping sound will be heard.
See chart below for further options:
Press the on/off button
Press once
Press twice
Press 3 times
Press 4 times
In timer mode:
- Start by selecting a colour that corresponds to the level of vapour emission required.
- Press the on/off button for 3 seconds, a beeping sound will be heard and the light will fl ash with the colour selected.
It will automatically go on for 2 hours.
- If you wish to turn the timer off , just press the on/off button again for 3 seconds, a beeping sound will be heard and the light will stop fl ashing.
Remote control (before using it, please remove the plastic strip on the battery)
You can also control the device using its remote control (Scheme 2):
- Press the button to start, select one of the four dispersion modes (consul the table above for more features) and stop the device.
- Press the button to turn the timer on or off for 2 hours.
9) When the water reservoir is empty, the safety system will stop the device automatically.
10) Switch off the "LIVING" essential oils humidifi er and diff user and unplug it.
IMPORTANT NOTES:
- Do not pour hot water above 40°C into the reservoir.
- Only use distilled or demineralised water to avoid any malfunction.
- To avoid any malfunction and fi re risk, do not pour water into the sprinkler tip (point at which the cold mist comes out of the device).
- Make sure the reservoir lid is tightly closed after fi lling so as to avoid leakage or potential electric shocks.
- The reservoir must be kept clean. If the nozzle emitting cold mist is dirty, clean it with a brush or damp cloth.
Please note: EVEN THOUGH THERE IS A SAFETY DEVICE THAT STOPS THE TRANSDUCER WORKING, DO NOT LEAVE THE DEVICE CONNECTED WHEN YOU ARE NOT USING IT.
Light
Orange
Green
Blue
Red
Cold mist level
Low
Medium
High
Low (night mode/timer: 5 hours)
EN
Living
7