Maintenance And Storage - Lanaform Living Mode D'emploi

EN ADDITIONAL INFORMATION RELATING TO THE USE OF ESSENTIAL OILS
- Before using the essential oils, please check the harmful eff ects that use of these products may have on your health.
- Always choose quality essential oils that are pure, 100% natural and intended for diff usion. Use them in moderation and with care. Follow the instructions and
warnings stated on the packaging of the essential oils, in particular by ensuring that:
• pregnant or lactating women, people with epilepsy, asthmatics and people suff ering from allergies and those with heart problems or serious illnesses do not
use essential oils.
• essential oils should only used for periods not exceeding 10 minutes in a baby's room (under 3 years old) and only when the baby is not actually in the room.
- Make sure that children and minors do not play with and use the device.
- Just a few drops (3 to 4 drops at most) of essential oils are suffi cient to ensure that the device works properly and the scent is being diff used. Excessive use of essential
oils could damage the device.
- Lanaform® cannot be held liable in the event of accidental damage resulting from any use contrary to the instructions given in this manual.

MAINTENANCE AND STORAGE:

If the water contains too much calcium and too much magnesium, it may deposit a "white powder" in the device. If this foam is deposited on the transducer (white
ceramic ring producing ultrasounds (k)), this will prevent the "LIVING" essential oils humidifi er and diff user from working properly.
MAINTENANCE
We recommend:
1) using distilled or demineralised water each time it is used.
2) cleaning the reservoir every 2 days and cleaning the transducer every week.
3) changing the water in the reservoir every 2 days.
4) cleaning the device (see explanations below) and making sure that all its parts are completely dry when it is not in use.
To clean the transducer (white ceramic ring (k)):
1) put 2 to 5 drops of vinegar on its surface and leave them there for 2 to 5 minutes.
2) brush the foam off the surface with a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the reservoir of the base in clean water.
4) Do not use soap, solvent or spray cleaner to clean the transducer.
To clean the water basin:
1) Clean the basin with water using a soft cloth and vinegar if there is foam or limescale deposits on the inside.
2) Rinse the basin in clean water.
To clean the cold mist emission nozzle of the device:
1) Clean this with a brush or damp cloth.
2) Rinse the nozzle in clean water.
STORAGE
Having cleaned and dried the device, store it in a dry, cool place out of the reach of children.
8