IMPORTANT SAFETY INSTRUCTIONS
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all Instructions.
5.
Do not use this apparatus near water.
6.
Clean only with dry cloth.
Do not block any ventilation openings. Install in accordance with the manufacturer‟s instructions.
7.
8.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9.
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one
wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third
prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement
of the obsolete outlet.
10.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11.
Only use attachment/accessories specified by the manufacturer.
12.
Use only the cart, stand, tripod, bracket or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13.
Unplug this apparatus during lightning storms or when unused for long periods of time.
14.
Refer all servicing to qualified service personnel.
apparatus has been damaged in any way, such as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
15.
Power Sources - This product should be connected to a power supply only of the type
described in these operating instructions, or as marked on the unit.
16.
Internal/External Voltage Selectors - Internal or external voltage selector switches, if any, should only be reset and re-
equipped with a proper plug for alternative voltage by a qualified service technician. Do not attempt to alter this yourself.
17.
Water and Moisture - This product should be kept away from direct contact with liquids. The apparatus shall not be
exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
18.
Batteries (a battery pack or an installed battery) shall not be exposes to excessive heat such as sunshine, fire, etc.
19.
Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.
20.
Protective earthing terminal: The apparatus should be connected to a mains socket outlet with a protective
earthing connection.
a. Finland (Suomi): Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.
b. Norway (Norge): Apparatet må tilkoples jordet stikkontakt.
c. Sweden (Sverige): Apparaten skall anslutas till jordat uttag.
21.
Do not install this equipment in a confined or "boxed-in" space such as a bookcase or similar unit, and maintain good
ventilation conditions. The ventilation should not be impeded by covering the ventilation openings with items such as
newspaper, tablecloths, curtains, etc.
22.
This apparatus is for professional use only.
23.
When moving or not using the appliance, secure the power cord (e.g., wrap it with a cable tie). Be careful not to damage
the power cord. Before using it again, make sure the power cord has not been damaged. If the power cord has been
damaged at all, bring the unit and cord to a qualified service technician for repair or replacement as specified by the
manufacturer.
24.
Do not place any open or exposed flame sources (such as lighted candles) on the apparatus.
25.
When disposing of the battery, follow the laws and environmental regulations of your region.
26.
WARNING: Excessive sound pressure (high volumes) from headphones can cause hearing loss.
27.
WARNING: Please refer to any important information (e.g., electrical, safety, etc.) printed on the exterior bottom
enclosure or rear panel before installing or operating the product.
Disconnect power cord before servicing.
Replace critical components
For AC line powered units – Before returning repaired unit to user, use an ohmmeter to measure from both AC plug blades
to all exposed metal parts. The resistance should be more than 2,000,000 ohms.
All manuals and user guides at all-guides.com
Servicing is required when the
SERVICE INSTRUCTIONS
only with factory parts or recommended equivalents.