Setting The Clock - SOUNDMASTER MCD5500 Mode D'emploi

Setting the clock

1. Set unit in standby mode.
2. Press and hold the "Mem/Clk-Adj" button (12) until display will flash "24HR". press the Skip Up
button (23/13) to select the clock format between 12 or 24Hour. Then press the "Mem/Clk-Adj" button (12).
3. The first digit of "0:00" is flashing on the LCD display (2). Press Skip Up
correct hour. Press "Mem/Clk-Adj" button (12) to store the correct hour.
4. The third & fourth digit of "00" is flashing; press the Skip Up
minutes. Then press "Preset/Clk-Adj" button (12) to store the correct minute.
The clock setting mode will automatically quit if no button is being pressed in a period of about 5 seconds after
pressing the "Mem/Clk-Adj" button.
The pre-set time will be re-set completely if dis-connecting the main power supply except backup battery installed.
You are recommended to switch the system into standby mode for convenience usage.
Listening to FM radio
Manual tuning
1. Plug in the provided DAB/FM tuner antenna to the antenna socket (30) then switch on the unit by On/Standby button (6),
then press Function button (10) to select " DAB " mode then press Band button (16) to select FM mode.
2. Tune to the required station by pressing the Tuning Up or Down button (23/13).
3. Turn the Volume knob (19) to the desired volume level.
Auto tuning (on the remote control only)
1. Set the unit to FM mode.
2. Press the Scan button once on the remote control; unit will start to scan at tuning up direct until radio station received. Press
and hold the Scan button on the remote control for a second, the unit will scan to tuning down direction. If the radio data
system (RDS) broadcasting signal received, the unit will set the actual time automatically.
3. Turn the Volume knob (19) to the desired volume level.
Radio data system (RDS)
This is the features to display the information which released from the radio broadcast and will showed on LCD display step by
step as below by pressing the Info button (on the remote control) continuously.
Radio text program type
Digital audio broadcasting (DAB) radio
1. Set the unit to "DAB" mode by Function button (10).
2. Press the Scan button on the remote control once; unit will start to full scan from range 11b-12d one time within around 2
seconds. Then press Tune up/down button (23/13) to select your desired DAB channel.
3. Press the Info button continuously to check the below info released by DAB.
Group name frequency
4. Press the Volume knob (19) to the desired volume level.
Preset stations
You can store up to total of 40 radio stations in the memory (20-FM/20-DAB).
1. Set to FM/DAB mode
2. Turn to the desired radio station by "manual" or "auto" tuning method.
3. Press and hold the Mem/Clock-Adjust button (12) around four seconds to enable memory state, the preset station will flash
on LCD display.
4. Preset the Folder/ Pre up button (22) to select the desired station memory for storage.
5. Press Mem/Clock-Adjust button (12) to confirm the preset memory.
6. Repeat step 2 to 5 to store other stations.
signal strength date/time
transfer rate signal strength
M_MCD5500SW / English Instruction Manual
or Skip Down
or Skip Down
frequency mono/stereo
date/time program type
or Skip Down
button (23/13) to set the
button (23/13) to set the correct
scrolling text
3