Pairing Bluetooth Devices; Listening To The Sound; Aux In Operation - SOUNDMASTER DISC5000 Mode D'emploi

signal to analogue audio signal, you can enjoy listening to the sound through this speaker system. AVRCP
(Audio/Video Remote Control Profile) is a technology that allows a single remote control to control all
Bluetooth enabled Audio Video equipment to which a user has access.
Notes when using unit with a mobile phone:
• This unit cannot be used to talk over the telephone even when there is a Bluetooth connection made to a
mobile phone.
• Please refer to the operating manual supplied with the mobile phone for details on operation of your mobile
phone while transmitting the sound using a Bluetooth connection.

Pairing Bluetooth devices:

Bluetooth devices need to be initially paired first before they can exchange data. Once paired, it is not
necessary to pair them again unless:
• Pairing is made with more than 8 devices. Pairing can only be made one device at a time. This unit can be
paired to a maximum of 8 devices. If subsequent device is paired, the oldest device paired, will be deleted
and replaced with the new one.
• This unit is reset. All pairing information is deleted when unit is reset.
• Pairing information is deleted while re-pairing, etc.
Pairing with other Bluetooth source devices:
1. Press the STAND-BY/ON button to turn the power on.
2. Press the SOURCE button (remote control) to select Bluetooth function. (PAIRING indicator blinks.)
3. Press and hold the PAIRING button for 3 seconds or more. PAIRING indicator blinks quickly. The unit is
now in pairing mode and is ready to be paired with other Bluetooth source devices.
4. Perform pairing procedure on the source device to detect this unit. "DISC5000" will appear in the detected
devices list (if available) in the source device. (Refer the source device operating manual for details).
NOTE:
• Place the devices to be paired within 1 meter (3 feet) of each other when pairing.
• Some source devices are unable to display lists of detected devices. To pair this unit with the source
device, refer to the source device operating manual for details.
5. Select "DISC5000" from the source list. If Passcode* is required, enter "0000". * Passcode may be called
PIN Code, Passkey, PIN number or Password.
6. Pairing indicator will stop blinking once the unit is successfully paired with the source device. (Pairing
information is now memorized in the unit.) Some audio source devices may connect with the unit
automatically after pairing is completed, otherwise follow the instructions in the source device operating
manual to start connection.
7. Press the play button on main unit source device to start Bluetooth connection.

Listening to the sound

Check that:
• The source device Bluetooth functionality is ON.
• Pairing of this unit and the source device is completed.
• Unit is in connected mode (pairing indicator (BT Link) of LCD.)
1. Press the STAND-BY/ON button to turn the power on.
2. Press the SOURCE button to select Bluetooth function.
3. Start the Bluetooth connection from the Bluetooth stereo audio source device.
4. Press play button (on main unit, remote control or source device).
NOTE:
If the source device has an extra bass function or equalizer function, set them to off. If these functions are on,
sound may be distorted.
1. Use a connection lead to connect the portable audio player etc. to the AUDIO IN socket. When using
video equipment, connect the audio output to this unit and the video output to a television.
2. Press the STAND-BY/ON button to turn the power on.
3. Press the SOURCE button on the remote control or SOURCE button repeatedly on main unit to select
AUDIO IN function.
4. Play the connected equipment. If volume level of the connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the
volume of the connected device.
NOTE: To prevent noise interference, place the unit away from the television.

AUX IN OPERATION

E-7