Minimum Distances; Installing The Template - Ariston NIVOS 25 MD0-O Manuel D'utilisation Et D'entretien

GB
1. INSTALLATION

1.1 Minimum distances

To ensure the appliance is installed correctly, keep to
the minimum distances indicated in figure "A" and leave
enough room for air to circulate freely. Use the accesso-
ries provided with the appliance to carry out the installa-
tion properly.
NOTES:
The dimensions of the internal and external units are giv-
en at the back of the manual.
WARNING:
- Make sure the installation site and any systems to
which the appliance must be connected comply
with the applicable standards in force.
- Use manual tools and equipment that are suitable
for the intended purpose.
- When lifting loads with a crane or hoist, make
sure the equipment used for lifting is stable and
efficient and suitably sized for the movement and
weight of the load itself; place the load correctly
in slings, tie ropes around it to limit any oscilla-
tions and lateral movements; lift the load from a
position where there is a full view of all the space
covered by the load during lifting; do not allow
people to pass or stop in the vicinity of the sus-
pended load.

1.2 Installing the template

NOTES:
Install the internal unit in a place free from all obstacles
(such as curtains) that could hinder the receipt of the re-
mote control signals and that allows for the air filters to
be pulled out without causing any inconvenience. Install
the internal unit in a position where the air flow will not be
obstructed.
WARNING:
Install the template on a solid wall that is not sub-
jected to any vibrations.
1. Using a mason's level, position the template in such a
way as to ensure it is perfectly on-axis, both vertically
and horizontally.
2. Fasten the template with 5 screws. Be careful not to
pierce or damage any pipes or wiring in conduits (risk
of personal injury from electrocution).
3. Then use the other screws to fasten the template to
the wall uniformly across the entire surface.
4. Make a hole in the wall for all piping and electrical con-
nections to pass through.
40 /
250
300
300
600
770 mm
173 mm 338 mm
ø 65 mm
28 mm
850 mm
266 mm 338 mm
ø 65 mm
122 mm
126 mm
Fig. "A"
150
250
300
600
300
600
2,5 kW
249 mm
ø 65 mm
25 mm
3,5 kW
ø 65 mm
160 mm