Installation; Installation Area; Minimum Distances - Ariston PROTech ALYS R32 Manuel D'installation

GB

1. INSTALLATION

1.1 Installation area

Make sure the installation site and any systems to which the
appliance must be connected comply with applicable regula-
tions. The interior unit should be installed in an appropriate
area with the following conditions:
- Good air circulation;
- Suitable drainage;
- The noise from the interior unit should not disturb other
people;
- Rigid and stable structure: the area should not be subject to
vibrations;
- The structure should be able to withstand the weight of the
unit;
- Observe a distance of at least 1 metre from any electrical
appliances (e.g. TV, radio, computer)
The unit should NOT be installed in the following places:
- near any source of heat, steam or combustible gas;
- near any fl ammable objects such as curtains or clothes;
- near obstacles that could obstruct the air fl ow;
- in a room subject to direct sunlight.
The appliance should be installed in a well ventilated area in
which the dimensions of the room are compliant with the sur-
face area.
FOR MODELS WITH REFRIGERANT R32:
- The appliance should be installed in a room with a sur-
face area larger than 4 m².
- The appliance cannot be installed in a room with no venti-
lation if the surface area is less than 4 m².

1.2 Minimum distances

To ensure the appliance is installed correctly, keep to the mini-
mum distances indicated in fi gure "A" and leave enough room
for air to circulate freely. Use the accessories provided with the
appliance to carry out the installation properly.
NOTES:
The dimensions of the internal and external units are given at
the back of the manual.
WARNING:
- Use manual tools and equipment that are suitable for
the intended purpose.
- When lifting loads with a crane or hoist, make sure
the equipment used for lifting is stable and effi cient
and suitably sized for the movement and weight of the
load itself; place the load correctly in slings, tie ropes
around it to limit any oscillations and lateral move-
ments; lift the load from a position where there is a full
view of all the space covered by the load during lifting;
do not allow people to pass or stop in the vicinity of
the suspended load.
44 /
300
250
300
300
600
300
600
Fig. "A"
250
300
600