MasterCraft 068-0558-4 Guide D'utilisation page 9

9. Align left drawer side panel (Part 12)
and right drawer side panel (Part 13) one
at a time to the back of the drawer front
panel (Part 11). Make sure both drawer
side panels are placed in contact with the
rear of the drawer front panel. Line up the
screw holes of the drawer side panels,
insert four M4 x 8 screws (Part 23) and
tighten them using the screwdriver (Part
21) (see Fig. I).
10. From above, attach drawer base
panel (Part 15) between the two drawer
side panels and to the back of the drawer
front panel (Part 11). Insert six M4 x 8
screws (Part 23) into the drawer base
panel and tighten them using the
screwdriver (Part 21) (see Fig. J).
Note:
Do not fully tighten any of the screws until
all screws are partially screwed in.
11. Attach the drawer back panel (Part
14) to the back of the assembled drawer.
Insert seven M4 x 8 screws (Part 23) into
the drawer back panel and tighten them
using the screwdriver (Part 21) (see Fig.
K).
12. Pull out the ball bearing track (1)
towards the front of the slider (2) (see Fig. L).
Note:
Do not fully tighten any of the screws until
all screws are partially screwed in.
Fig. I
Fig. J
Fig. K
Fig. L
7