MasterCraft 068-0558-4 Guide D'utilisation page 7

3. Place the left panel (Part 4) on the solid
wood board (Part 10). Make sure the top
of the left panel is aligned with the screw
holes on the front frame (Part 2) and the
solid wood board. Attach the left panel to
the solid wood board and front frame. Add
three washers (Part 28) to the three M4 x
10 screws (Part 22) that will attach the
solid wood board; no washers are
necessary with the three M4 x 10 screws
(Part 22) that attach the front frame.
Tighten the screws using the screwdriver
(Part 21) (see Fig. C).
4. Place the right panel (Part 3) on the
solid wood board (Part 10). Make sure the
top of the right panel is aligned with the
screw holes on the front frame (Part 2)
and the solid wood board. Attach the right
panel to the solid wood board and front
frame. Add three washers (Part 28) to the
three M4 x 10 screws (Part 22) that will
attach the solid wood board; no washers
are necessary with the three M4 x 10
screws (Part 22) that attach the front
frame. Tighten the screws using the
screwdriver (Part 21) (see Fig. D).
5. Attach the upper back panel (Part 7)
and bottom back panel (Part 6) between
the left panel (Part 4) and right panel (Part
3). Make sure the top of the upper back
panel is on the solid wood board. Line up
the screw holes of the back panels. Insert
13 M4 x 10 screws (Part 22) and tighten
them using the screwdriver (Part 21) (see
Fig. E).
Fig. C
Fig. D
Fig. E
Note:
Four screw holes provided at top end of the
upper back panel are reserved for corner protectors.
5