Installing The Appliance; Note Ambient Temperature And Ventilation; Connecting The Appliance - Siemens KSW Serie Notice D'utilisation Et De Montage

Installing the appliance

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
30 cm to an oil or solid‐fuel cooker.
Note ambient
temperature and
ventilation
The climatic class can be found on the
rating plate. It specifies the ambient tem­
peratures at which the appliance may be
operated.
Climatic category
SN
N
ST
T
Ventilation
Fig. "
The air on the rear panel of the appli­
ance heats up. The warm air must be
able to escape. Otherwise, the refrigera­
tor must work harder. This will increase
the power consumption.
Permitted ambient
temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
For this reason pull up the spacers pro­
vided on the appliance's rear panel for
the optimum distance to the wall Fig #.
Never cover or block the ventilation
openings!
Connecting
the appliance
After installing the appliance, wait at
least 1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket should be freely accessible.
Connect the appliance only to
220–240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
If the appliance is to be operated in
a non‐European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left‐hand side of the appliance.
The power cord may be replaced by
a technician only.
!
Warning
Never connect the appliance to
electronic energy saver plugs or to
power inverters which convert the direct
current to 230 V alternating current (e.g.
solar equipment, power supplies on
ships).
en
19