Product Maintenance - Fellowes Microshred 62MC Mode D'emploi

BASIC SHREDDING OPERATION
Continuous operation:
Up to 7-minutes maximum
NOTE: Shredder runs briefly after each pass to
clear entry. Continuous operation beyond 7-minutes
will trigger 60-minute cool down period.
Safety Lock prevents accidental operation.
To unlock, slide black button up. For greater safety, always unplug shredder after use.

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse ( ) Alternate slowly back and forth
for 2-3 seconds
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, press reverse (
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
The benefits under Fellowes' Warranty are in addition to other rights and remedies under a law in relation to the shredder.
PAPER/CARD
1 2
Plug in and set to Feed paper/card
Auto-On ( ) straight into paper
entry and release
To set, wait for shredding to stop, set control switch to Off ( ) position, then slide black button down.
3 4
Set to Off ( )
and unplug
3
When finished shredding,
set to Off ( )
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
*Apply oil across entry
Set to Off ( )
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
5 6
Set to Auto-On (
Gently pull uncut
and resume shredding
paper from paper
entry. Plug in
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
more details or to obtain service under this warranty, please contact us or your dealer.
3 4
Set to Reverse ( ) Set to Off ( )
for 2-3 seconds
Shredder doesn't start:
Make sure switch is in on position ( ).
Make sure safety lock is in unlock position.
Make sure bin is closed.
)
Check for jam.
Remove and empty bin.
Wait 60 minutes for motor to cool down.
3