Product Maintenance - Fellowes Powershred 92Cs Mode D'emploi

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 30 minutes will
trigger 50-minute cool down period.
ADVANCED PRODUCT FEATURES
SafeSense Technology
®
Stops shredding immediately when
hands touch the paper entry.
SAFESENSE TECHNOLOGY OPERATION
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1 2
to activate SafeSense look for the SafeSense
®
indicator to illuminate
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
recommend you oil your shredder each time you empty
your waste bin.
* Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
indicator will remain illuminated and the shredder will
the continuous operation and recovery time for this shredder.
Remove Paper: When illuminated, press reverse (
SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
PAPER, CARD or CD
1 2
Plug in and put
disconnect power switch into paper entry
and release
Auto Reverse
Stops and reverses paper
if a jam occurs.
3
SafeSense is active and
®
working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
)
3 4
or
Hold card/CD at edge.
When finished
shredding set to
entry and release
Sleep Mode
the shredder after 2 minutes
of inactivity.
SLEEP MODE OPERATION
2 minutes of inactivity.
WHEN IN SLEEP MODE
1
In sleep mode
2 3
Press and hold Reverse
*Apply oil across entry
( ) 2-3 seconds
indicator will illuminate and the shredder will stop shredding.
®
)
SilentShred™ Technology
Shreds without noisy disruptions.
2
insert paper
3