Silver Cross Wave Instructions D'installation page 16

16
THE CHASSIS OR DAMAGE MAY
OCCUR.
ANY LOAD ATTACHED TO THE
HANDLE AND/OR BACKREST
AND/OR SIDES OF THE VEHICLE
WILL AFFECT STABILITY OF THE
VEHICLE.
CARE MUST BE TAKEN WHEN
FOLDING AND UNFOLDING THE
CARRIAGE OR STROLLER TO
PREVENT FINGER ENTRAPMENT.
THE CARRIAGE OR STROLLER
WILL BECOME UNSTABLE
IF THE MANUFACTURER'S
RECOMMENDED LOAD IS
EXCEEDED. MAXIMUM LOAD OF
STROLLER IS 51.34KG
THE CARRIAGE OR STROLLER
WILL BECOME UNSTABLE IF A
PARCEL BAG OR PARCEL RACK
IS USED WHEN THERE IS NO
PROVISION FOR ONE.
DO NOT LIFT A SEAT OR BASSINET
VIA THE BUMPER BAR WHILST A
CHILD IS IN PLACE. THE BUMPER
BAR IS NOT A CARRY HANDLE.
DO NOT LIFT THE BASSINET
FROM THE BUMPER BAR.
THE HEAD OF THE CHILD IN THE
BASSINET SHOULD NEVER BE
LOWER THAN THE BODY OF THE
CHILD.
BEFORE CONVERTING THE
WAVE FOR USE IN TANDEM
CONFIGURATION, APPLY THE
PARKING BRAKE AND REMOVE
ANY CAR SEAT OR BASSINET.
NOTE: THE BASSINET CAN FIT IN
BOTH THE WAVE CONNECTORS
ENG FRA
Wave Tandem Seat Jan 2019-CANADA.indd 16
AND THE TANDEM CONNECTORS
REARWARD FACING ONLY.
THE BASSINET ADAPTORS
ARE ONLY TO BE USED WITH A
TANDEM SEAT OR BASSINET IN
THE TANDEM POSITION.
THE BASSINET ADAPTORS MUST
BE REMOVED FROM THE CHASSIS
BEFORE RETURNING THE WAVE
CHASSIS BACK TO A SINGLE
CONFIGURATION.
THE BASSINET ADAPTORS
CAN ONLY BE USED WITH
THE BASSINET AND MUST BE
REMOVED BEFORE FITTING THE
PUSHCHAIR SEAT.
THE TANDEM CONNECTORS CAN
ONLY BE REMOVED FROM THE
CHASSIS ONCE THE TANDEM
SEAT, BASSINET OR CAR SEAT
ADAPTOR HAS BEEN REMOVED.
WHEN A CAR SEAT IS USED ON
THE WAVE CONNECTORS IN
THE SECONDARY POSITION,
THE HANDLE HEIGHT MUST BE
IN EITHER OF THE HIGHEST 2
POSITIONS. EITHER ONE OR TWO
MUST BE VISIBLE WHEN THE
HANDLE IS AT THE CORRECT
HEIGHT.
18/01/2019 16:07