Shaper Origin S01-EN Guide D'utilisation page 13

Safety & Care
Power Tool Use and Care
Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at the
rate for which it was designed.
Do not use the power tool if the switch does not
turn the spindle on and off. Any power tool that
cannot be controlled with the switch is dangerous
and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused
by poorly maintained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
16
Safety & Care
Use the power tool, accessories, and tool bits
etc. in accordance with these instructions, taking
into account the working conditions and the
work to be performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation.
Keep Origin's mechanisms clean. Wearing suitable
eye protection, use vacuum to remove debris from
Origin's mechanisms.
Periodically open chip tray to remove debris.
Service
Have your power tool serviced by a qualified
repair person only using identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
Origin is covered by a warranty. Call or email
Shaper support (support.shapertools.com) if you
believe Origin requires servicing beyond what is
listed in the "Use and Care" section.
shapertools.com 17