Shaper Origin S01-EN Guide D'utilisation page 9

Basics
Changing the Router Bit
To change router bits, first unplug the SM1
Spindle from Origin and remove it from the
spindle mount, as described earlier. Press the
collet lock while loosening or tightening the collet
locking nut with the included 19mm wrench. Do
not tighten the collet locking nut until a router bit
is inserted.
WARNING: Maximum allowable cutter diameter is
1 inch (25 mm).
Powering Origin
Plug Origin into a grounded wall outlet, either
directly, or through a properly rated extension
cord, surge protector, or power strip.
WARNING: Do not plug Origin into the switched
outlet available on some dust extractors.
Unlike most power tools, Origin has an internal
computer, making these outlets unsuitable for
Origin.
8
Basics
Safety first. Always use eye and ear protection
when operating Origin. Always keep the finger
guard installed when the spindle is plugged in.
Keep fingers and other body parts away from the
collet and the router bit.
material
spoil board
table
When setting up your workpiece, use clamps,
adhesives, or other practical means to secure
the workpiece to a stable work table. It is
recommended to use a spoil board underneath
your material when doing a through-cut.
shapertools.com 9