Personal Safety - Shaper Origin S01-EN Guide D'utilisation

Safety & Care
Do not expose power tools to rain or wet
conditions. Water entering the power tool will
increase the risk of electric shock.
Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords
increase the risk of electric shock.
When operating power tools outdoors use an
extension cord suitable for outdoor use. Use of
a cord suitable for outdoor use reduces the risk
of electric shock.
If operating a power tool in a damp location
is unavoidable, use a ground fault circuit
interrupter (GFCI) protected supply. Use of a GFCI
reduces the risk of electric shock.
Use appropriate extension cords. Only use
undamaged extension cords that match Origin's
plug. Extension cords should have an adequate
voltage and current rating that meets or exceeds
the electrical specifications listed on the
product label.
Always make sure that the spindle motor
connector is securely plugged into the side of
Origin while operating.

Personal Safety

Stay alert, watch what you are doing and use
common sense when operating power tools. Do
not use power tools while you are tired, or under
the influence of drugs, alcohol, or medication.
A moment of inattention while operating power
tools may result in serious personal injury.
14
Safety & Care
Use personal protective equipment. Always
wear eye protection. Protective equipment such
as dust masks, non-skid safety shoes, hard
hats, or hearing protection used for appropriate
conditions will reduce personal injuries.
Prevent unintentional starting. Ensure the switch
is in the OFF position before connecting to power
source, picking up or carrying the tool. Carrying
power tools with your finger on the switch or
energizing power tools that have the switch on
invites accidents.
Remove any adjusting key or wrench before
turning the power tool on. A wrench or a key left
attached to a rotating part of the power tool may
result in personal injury.
Do not overreach. Keep proper footing and
balance at all times. This enables better control
of the power tool in unexpected situations.
Dress properly. Do not wear loose clothing or
jewelry. Keep your hair, clothing, and gloves
away from moving parts. Loose clothes, jewelry
or long hair can be caught in moving parts.
If devices are provided for the connection of
dust extraction and collection facilities, ensure
these are connected and properly used. Use of
dust collection can reduce dust-related hazards.
shapertools.com 15