Configuring The Network Card; Networks With Dhcp Server - R&S ETC Guide Rapide

R&S ETC
6.3

Configuring the Network Card

Under Windows CE 5.0, network card drivers do not need to be installed separately. If
the R&S ETC is connected to the LAN, Windows CE 5.0 automatically detects the
network connection and activates the required drivers.
The configuration tasks depend on whether your network has a DHCP server or not. If
necessary, ask your network administrator.
6.3.1

Networks with DHCP Server

In networks using the dynamic host configuration protocol (DHCP), the R&S ETC is
automatically assigned a free IP address when connected to the network.
Activating DHCP
For this purpose, DHCP must be activated on the R&S ETC. By default, DHCP is
activated. If the setting has been altered, proceed as follows.
1. Press the SETUP key.
2. Tap INSTRUMENT SETUP.
The R&S ETC opens a list of general settings.
3. Under LAN PORT, select DHCP MODE.
A selection list opens.
4. Select ON.
DHCP is activated on the R&S ETC, and the DHCP server can allocate an IP
address and a subnet mask to the R&S ETC. This process can take several
seconds.
Under the LAN PORT, the assigned values are displayed in the IP ADDRESS and
SUBNET MASK fields.
Getting Started 2116.7884.02 - 04.00
Operating the Instrument in a LAN
40